I need a clear answer on how to get my headset to work

[Run4YaLife]

Ports Used by SOCOM 3: (They are all Confirmed)
TCP 10070 - 10080
TCP 80
UDP 6000 - 7000
UDP 10070
UDP 50000
USE PORT FOWARDING ONLY (Not Trigger Port)

Thanks to Drako_MDS

[BILLLDozeR]

yea i no that but what about this dmz bullstuff i dont no what to put in the dmx box???

[I Sniped Hitler]

Originally Posted by Run4YaLife

Ports Used by SOCOM 3: (They are all Confirmed)
TCP 10070 - 10080
TCP 80
UDP 6000 - 7000
UDP 10070
UDP 50000
USE PORT FOWARDING ONLY (Not Trigger Port)

Thanks to Drako_MDS

Thanks for the ports, and what do I put in for DMZ like Billdozer said

[BILLLDozeR]

just put the same 3 digit number that u put in all the port boxes

[I Sniped Hitler]

Originally Posted by BILLLDozeR

just put the same 3 digit number that u put in all the port boxes

What like 192.168.1.200 that I used for the IP address?

BTW did you get yours working?

[Da3m0n]

What modem do you have.....version of router.....i had the same problems and found out that i actually needed to update my modems firmware and configure it......i had to do no configuring with my WRT54G....ever since my mics have worked fine on socom3 and FTB

[Da3m0n]

On a side note .......if you forward the ports.....forget about DMZ'n your PS2

[I Sniped Hitler]

Originally Posted by Da3m0n

What modem do you have.....version of router.....i had the same problems and found out that i actually needed to update my modems firmware and configure it......i had to do no configuring with my WRT54G....ever since my mics have worked fine on socom3 and FTB

Ok download the firmware and then what do I configure, I know how to get my routers configuration but what do I change around. The ports? Sorry I know im askign a million questions but I tried the stuff from the sticky thread and I was spending all last night undoing what I did since it was screwing up my internet connection.

[I Sniped Hitler]

bump, Im pretty close to figuring this out but still need some help like where do I download the firmware thing, what do I do after that and if I have to open those ports what do I write in the boxes under the title application when i go to the port range forwarding screen.

[I Sniped Hitler]

gahhhhhh bump, this thing is pissing me off im going insane